Pason WITS Operation & User’s Manual

14, Revised May 1, 2019 Revision 25 of DOCU225, © Copyright Page 14 of 44 4 Setting Up WITS in the EDR After connecting the hardware, you need to use the EDR to set up WITS communication. Set up procedures vary depending on whether you connected the WITS device to the EDR via a comm …

33, Pason WITS Revised May 1, 2019 Revision 25 of DOCU225, © Copyright Page 33 of 44 Name WITS Code EDR can Receive EDR Sends in Full WITS Mode EDR Sends in Half WITS Mode 3 rd Party Gas 0140 Y Y Mechanical Specific Energy 0141 Y TotalPumpDisp…

9, Revised May 1, 2019 Revision 25 of DOCU225, © Copyright Page 9 of 44 3 Connecting Hardware for WITS Communication WITS communication requires a physical connection between Pason and third-party systems. This section includes information about how to complete the …

3, Revised May 1, 2019 Revision 25 of DOCU225, © Copyright Page 3 of 44 Table of Contents 1 Overview ............................................................................................ 6 2 Understanding Pason WITS .......................................................…

2, Revised May 1, 2019 Revision 25 of DOCU225, © Copyright Page 2 of 44 This document contains proprietary information and is not intended for public distribution. Pason Systems and all other trademarks and trade names used in this document, unless otherwise specified, are t…

32, Revised May 1, 2019 Revision 25 of DOCU225, © Copyright Page 32 of 44 4.11 Default Pason WITS Codes The following table lists the default Pason WITS names and codes, whether the EDR can receive the code, and which codes are sent in the different EDR WITS modes. In addition, the …