Tangent Scale Models PS-2CD 4000 Instructions Manual

11, Tangent Scale Models PS-2CD 4000 Kit Assembly Instructions 11 10. Attach the A end uprights: Using sprue nippers, carefully degate and clean the A end uprights found on the “End frames“ sprue. Cut the tops of the end uprights square using sprue nippers. Test fit on A end, an…

10, Tangent Scale Models PS-2CD 4000 Kit Assembly Instructions 10 9. Attach the brake cylinder/fulcrum/clevis/horizontal support piece to the coupler underframe and slope sheet: Degate and clean the brake cylinder/fulcrum/clevis/horizontal support piece, located on the “Brake Details…

2, Tangent Scale Models PS-2CD 4000 Kit Assembly Instructions 2 1. Cleanup: Turn car over onto the roof, and with a chisel blade knife remove the sprue scrap from the bottom center of the center bay. Keep the 2 parallel mounting “circles” intact – these note which w…

8, Tangent Scale Models PS-2CD 4000 Kit Assembly Instructions 8 7. Attach bolster plates: Degate and clean the two bolster plate parts. These need to be cleaned especially well on the sides because this signature part is visible above the trucks of the car. The parts shou…

19, Tangent Scale Models PS-2CD 4000 Kit Assembly Instructions 19 28. Attach the Stirrup Steps: Carefully degate the corner steps and attach them to the underside of the car. Note: When degating the steps, leave the plastic tabs where the step will insert into slots on the underside of…