Teledyne Lecroy Summit Z416 Quick Start Manual

4, Assembly Instructions If the Summit Z416 is to be used to emulate a root complex it will usually be installed in the Teledyne LeCroy PXP-400 ™ or Teledyne LeCroy PCI Express Gen4 Test Platform. In this case please refer to the Teledyne LeCroy PXP-400 or PCI Express Gen4 Test Platform Quick Star…

7, Installing the Software To install the software download the latest software by going to teledynelecroy.com/sw/pciexpress or follow the steps below if you have the PCIe Protocol Suite installation DVD: Note: You must install the software before connecting the Summit Z416 to the ho…

1, Introduction The Summit Z416 is Teledyne LeCroy’s fifth generation protocol exerciser (traffic generator), providing support for the PCI Express 4.0 specification with up to x16 lanes and up to 16.0 GT/s data rates. The Summit Z416 can emulate either a PCI Express Root Complex or Device End…

8, Teledyne Lecroy Summit Z416 Trademarks and Servicemarks Teledyne LeCroy, PCIe Protocol Suite, PCIe Protocol Analysis, Summit Z416, PXP-400 and PCI Express Gen4 Test Platform are trademarks of Teledyne LeCroy. Microsoft and Windows are registered trademarks of Microsoft Inc. All other trademarks are property …

3, Main Board: Interface Connector to Controller Board Ribbon Cable from Controller Board to Main Board Main Board Interface Connector PCIe Edge Connector 12 Inch Ribbon Cable …

6, 7. Plug in the output cable of the Power Adapter to the power connector on the Summit Z416 Controller Board (see figure below): 8. Install the PCIe Protocol Analysis Software following the steps below (See section "6"). 9. Power ON the Summit Z416 system. 10. Use PCIe Protocol Analysis S…