SAS BIO SOLID 19 Operation And Maintenance Manual

42, 42 for this purpose. Were the boiler is extinguished and cooled down, clean the com- bustion chamber and exhaust ducts through the clean out holes and inspection doors on the front wall of the boiler. To do this, remove the cover of the top clean out. The access for cleaning of vertica…

53, SAS BIO SOLID 19 53 • Moving grate drive motors • The electrical heater (fuel burner) • Automatic fuel feeding system and its parts • Analogue thermometer 5. The warranty does not cover components subject to wear and tear: • Screws, nuts, handles • Sealant (sealing elements), r…

20, 20 Figure 6. BOILER DESIGN DIAGRAM SAS BIO SOLID 14-48 KW BOILER * thermal protection against overheating (e.g., Regulus BVTS for an open vented system with a plate exchanger or SYR 5067 for a sealed system) is not included in the boiler standard equipment. ** the n…

17, 17 A supply water connector is welded to the upper part of the heat exchan- ger, while a return water connector is welded at the bottom, on the back wall. A discharge connector (G ¾”) is located on a side wall in the bottom part of the boiler. It is also used for connection of cooling wate…