Sanus CFR21 Series Instruction Manual

18, 6901-002133 <00> 44 English Milestone AV Technologies and its a liated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all det…

12, 6901-002133 <00> 12 9 Switch Back Panels To switch the position of the back panels: 1. Remove large upper panel. 2. Remove small lower panel and frame. 3. Fit bottom of large panel into rack frame and angle the panel up until sliding locks snap in place. 4. Flip small panel 18…

6, Sanus CFR21 Series 6901-002133 <00> 6 1 Install Feet and Casters 2 Level Feet [03] [03] [04] [05] [03] (N) Install feet [03]. Install Casters [04] using screws [05]. Adjust the feet [03] to level the rack. Tighten nuts (N) until they are  ush with the bottom of the rack. CAUTION: To avoid potential…

8, 6901-002133 <00> 8 4 Verify the Grounding Strap has been Installed If the grounding wire has not been installed, install the wire now by attaching one end to the door ground stud, and the other end of the ground wire to the ground stud on the bottom of the rail. CAUTION: Avoid …

11, 6901-002133 <00> 11 8 Load Your Components CAUTION: To prevent tipping, always load the rack from the bottom up, and load the heaviest item in the rack  rst. 50% of the total weight should be mounted in the lower ⁄ of the rack. Rack Shelf Backstops OPT NOTE: …