Ronin Lift Instruction Manual

9, Page 9 of 31 Ronin Lift Personal Ascender 1 – Ronin Lift Personal Ascender 2 – Lithium Ion Rechargeable Battery 3 – Battery Indicator 4 – Brake/Repel Handle 5 – Tensioner Knob 6 – Carabineer Clip Attachment Point 7 – Handle 8 – Thumbwheel 9 – Motor/Gearbox 10 �…

22, Page 22 of 31 6. Once rope is no longer feeding into the device apply tension via the tensioner by rotating the tensioner knob in the counterclockwise direction. Note: Rotate the tension knob counterclockwise until the knob is tight and will not physically rotate anymore…

2, Page 2 of 31 WARNING: To avoid electrical shock, do not open the Ronin Lift’s front cover. Refer servicing to qualified personnel only. Caution: Modification of controls or adjustment or performance other than specified by procedures herein may results in injury or death. You are cau…

13, Ronin Lift Page 13 of 31 Ronin Lift Device Labels 1) Warning Label instructions user to read the entire instruction manual and have a thorough understanding of the device prior to use. Please contact customer service if you are unsure of anything prior to use. 2) The Ronin Lift label pro…

10, Page 10 of 31 Specification Ronin Lift Motor 28 VDC nominal 100 amps (1 min burst) 275º F (135º C) max operating Temp 4500 rpm 5 N-m continuous torque Gearbox 32:1 reduction Speed Controller Pulse Width Modulation (PWM) 120 amps max 32 VDC Max Thumbwheel .381k ohm …

20, Page 20 of 31 Loading Rope 1. Rotate the tensioner dial knob in the clockwise direction until it bottoms out on the Ronin Lift ascender housing. This will relieve the tension allowing the first wrap to be started. Only rotate the knob until it stops. Note: Screw the tensi…