Micronics Ultraflo 2000 Operating Manual

14, ULTRAFLO 2000 INSTALLATION & OPERATING INSTRUCTIONS 14 The display will show the following. SETUP 4-20MA Max. 1000 This function allows the user to scale the 4-20mA. Press ENTER to select and enter your required maximum flow rat…

7, Micronics Ultraflo 2000 ULTRAFLO 2000 INSTALLATION & OPERATING INSTRUCTIONS 7 • If data has been incorrectly entered, press Y until the display is clear, then re-enter the data correctly. Restart Key The RESTART key can be pressed at any point in the program and will take the instrument back to the ope…

5, ULTRAFLO 2000 INSTALLATION & OPERATING INSTRUCTIONS 5 Transducer Hardware Transducer alignment guide rails, chains and couplant are supplied with all units in order to ensure that the transducers are accurately aligned with respect to the pipe axis. A single guide rail assembl…

10, ULTRAFLO 2000 INSTALLATION & OPERATING INSTRUCTIONS 10 From the MAIN MENU select View/Edit site data by pressing ENTER. This enables the user to view and edit the application data that has been entered into the unit previously. The display will show the following. Press ENTER…

4, ULTRAFLO 2000 INSTALLATION & OPERATING INSTRUCTIONS 4 INTRODUCTION The Ultraflo 2000 is a “Clamp-on” liquid flow meter that uses the Transit Time method of measurement to read flow. Using two PT100 temperature probes to measure temperature it can also be used as a …

22, ULTRAFLO 2000 INSTALLATION & OPERATING INSTRUCTIONS 22 CE MARKING The Ultraflo 2000 has been tested and found to conform to EN50081 - 1 Emission Standards and EN50082 - 1 Immunity Standards. The tests were conducted by AQL - EMC Ltd, of 16 Cobham Road, Ferndown Industrial Est…