Ogden OGM1900 Manual, Installation Instruction

2, NOTE THE PRINCIPLES FOR ARCS OR WAVES APPLY TO ALL MOUNT STYLES. SEE WALL MOUNT AND CANTILEVER INSTALLATION PAGES FOR SPECIFIC DETAIL REGARDING THEIR INSTALLATION. OPEN LAYOUTS REFER TO ANY LAYOUT WITH A BEGINNING AND AN END (IE. NOT A CIRCLE). ARC OR WAVE (OPEN LAYOUTS) NOTE TH…

12, DETAIL B FLAT WASHER LOCK WASHER HEX NUT STUDS DETAIL C TURN SEAT SECTION ON BACK, ENSURE TO PLACE ON A CLEAN SCRATCH RESISTANT SURFACE. FIRST IDENTIFY THE BEGINNING OF CHOSEN LAYOUT AND ALIGN LEG TO ALL 4 STUDS (DETAIL B). IF CONTINUING LAYOUT ALIGN SECOND LEG WITH 2 STUDS AND OVER…

3, CENTER ARM OR SKATE DETERRENT CANTILEVER MOUNT FOR WALL MOUNTS BENCHES PRINCIPLES APPLY TO BOTH OPEN OR CLOSED LAYOUTS (REFER TO PAGE 1) WALL MOUNT NOTE PRINCIPLES FOR ASSEMBLY ARE THE SIMILAR FOR BOTH THE CENTER ARM AND THE SKATE DETERRENT. FOR CANTILEVERED SECTIONS PRINCIPLES APPLY TO BOTH O…

5, Ogden OGM1900 15 3/8" 17 1/4" 9/16" HOLE FOR CONCRETE ANCHOR 17 1/4" 11 1/2" 2" !CAUTION! - FOR REFERENCE ONLY. DIMENSIONS ARE SUBJECT TO CHANGE AND MAY VARY. USE ACTUAL PRODUCT TO MARK HOLE LOCATIONS. WWW.MAGLIN.COM THE INFORMATION CONTAINED IN THIS D…

17, DETAIL E DETAIL F ALIGN BOTTOM HALF OF BRACKET WITH HOLES THAT HAVE BEEN DRILLED AND FASTEN DOWN WITH CHOSEN CONCRETE ANCHORS (DETAIL D). ALIGN BENCH WITH BRACKETS. USING 7/32" ALLEN KEY FASTEN BENCH SECTION TO BRACKETS (DETAIL F) USING FASTENERS PREVIOUSLY REMOVED. WWW.MAGLIN.COM …

10, DETAIL B HEX NUT LOCK WASHER FLAT WASHER DETAIL C HEX NUT LOCK WASHER FLAT WASHER FLIP OVER BENCH SECTION. NEXT PLACE NEXT SEAT SECTION ONTO SEAT SURFACE. AGAIN ENSURE IT IS PLACED ON A CLEAN SCRATCH RESISTANT SURFACE. ATTACH NEXT LEG BY ALIGNING LEG TO 2 THREADED STUDS ON SEAT TO 2 HOLE…