NewLife Intensity 10 Service Manual

13, MN134-1 rev B 02/14 8 4.0 Provider Instructions 4.1 Instructions To ensure that the unit’s output of oxygen is within specification, you must perform a test of the oxygen concentration. Test the unit upon delivery to a patient and at periodic intervals. Equipment Providers…

7, NewLife Intensity 10 MN134-1 rev B 02/14 2 1.2 Important Notice and Symbol Explanations As you read the manual, pay special attention to the WARNING, CAUTION, and NOTE messages. They identify safety guidelines or other important information as follows: Describes a hazard or unsafe practice that can…

28, MN134-1 rev B 02/14 23 Problem Probable Cause Solution Compressor runs with intermittent high pressure alarm and low oxygen concentration. Restriction in exhaust muffler. Faulty solenoid valve. Faulty circuit board. Contaminated sieve beds. Replace or …

26, MN134-1 rev B 02/14 21 6.2 General Troubleshooting Before reviewing the troubleshooting chart, the following steps may be useful to isolate any malfunctions: 1. Turn on the concentrator. If the unit does not turn on, refer to the troubleshooting chart. 2. Verify…

31, APPENDIX • Exploded drawings Wiring Diagram – Intensity 10 120V A Wiring Diagram – Intensity 10 220/240V B Control Panel Assembly C Main Structure Assembly D Base and Cabinet Components E P…

30, MN134-1 rev B 02/14 25 6.4 Tool Kit and Pressure Test Gauge The tools needed for you to properly service the NewLife Intensity 10 unit are listed below: Multi-adjustable pliers, wire cutters, needle-nose pliers, slotted-head screwdriver, Phillips- head screwdriver, rat…