New Leader Guardian L3030G4 MultApplier Operator's Manual

59, - 59 - L3030G4 CNH www.NewLeader.com (800) 363-1771 307369-AA-G Header CONVEYOR GEARCASE Drain oil in a new unit after fi rst two weeks (or not more than 100 hours) of operation, and fl ush gear case thoroughly with light oil. Refer to “Lubricant and Oil Specifi cations” section fo…

88, 88 Spread Pattern Verifying Driving Centers Once optimum driving centers (effective swath width) have been established, conduct a fi nal “S” pass over the trays to verify. Refer to Figure 17. 1. With both the spinners and conveyor turned off, drive the spreader through …

11, New Leader Guardian L3030G4 MultApplier - 11 - L3030G4 CNH www.NewLeader.com (800) 363-1771 307369-AA-G Header AVOID MOVING PART HAZARDS Figure 1.8 - Entanglement in rotating drive lines or moving parts will cause serious injury or death. Stay clear of all moving parts, such as shafts, couplings and universal joints. Make sure all…

35, - 35 - L3030G4 CNH www.NewLeader.com (800) 363-1771 307369-AA-G HeaderInsert Installation HILLSIDE DIVIDER & CONVEYOR COVER NOTICE! Highway Equipment Company will not be liable for misapplied material due to an improperly adjusted divider, spreader or both. Figure 19A - MULTAPPLIER Hill…

24, - 24 - www.NewLeader.com (800) 363-1771 307369-AA-G L3030G4 CNH This page is intentionally left blank. Notes …

56, - 56 - www.NewLeader.com (800) 363-1771 307369-AA-G L3030G4 CNH Header NOTE: This pulley moves up and down ONLY. Loosen belt and raise or lower as necessary. Loosen the two bolts holding the snubber bearing on the side to be adjusted after marking the old position. Move appro…