Lumos GSX Installation Manual

6, Lumos GSX Mullion Screw TBD per project requirements Mullion screws pierce base of mullion. Pre-drilling may or may not be required, depending on fastener spec. Page 6 Date Modified: Feb 10, 2016 File Name: 20160210_Rev004_GSX Installation Manual NOTES: 1.Use only 300 series stainless steel …

23, Follow the same pattern to install the rest of the modules. Be sure to apply caulk to the transoms and weatherseals. All wiring must be completed as the modules are installed, as the wire ways will be inaccessible once all modules are in place. Page 23 Date Modified: Feb 10, 2016 File Name: 20…

8, Page 8 Date Modified: Feb 10, 2016 File Name: 20160210_Rev004_GSX Installation Manual NOTES: 1.Tolerance on Mullion placement is +/- 1/8". 2.VISUALLY INSPECT each interior transom to ensure it is centered, +/- 1/16", under the gap between modules (the modules must be dry f…

25, Page 25 Date Modified: Feb 10, 2016 File Name: 20160210_Rev004_GSX Installation Manual Electrical Installation Grounding/Electrical Bonding Information (continued on next page) Top Cap is bonded to pressure plate via direct metal to metal contact inside the snap fit Mullions can be g…

20, Caulk is shown in green for visibility. Actual color will not be green. Install weatherseal (i.e., caulk the joint. Tape off and tool back to ensure a clean finish.) Page 20 Date Modified: Feb 10, 2016 File Name: 20160210_Rev004_GSX Installation Manual Mechanical Installation …

27, Page 27 Date Modified: Feb 10, 2016 File Name: 20160210_Rev004_GSX Installation Manual Walking on the Array Lumos permits stepping and walking on our GSX modules, but ONLY OVER THE TRANSOMS AND MULLIONS. Stepping anywhere other than these locations, which are highlighted in green with h…