Hewlett Packard Enterprise AP-303H-MNTW Installation Manual

1, AP-303H-MNTW Wall Mount Kit Installation Guide 0511980-02 | April 2017 1 Package Contents  AP-303H-MNTW plastic mount bracket  (2) Blank Keystone jack cover  (2) #6-32 x 1.5” slotted screws  M2.5 x 0.45P x 6.5 security screw  AP-303H-MNTW Wall Mount Kit Installation Guide Introducti…

2, 2 AP-303H-MNTW Wall Mount Kit | Installation Guide Figure 1 Attaching the AP-303H-MNTW to a flat surface Installing the AP-303H-MNTW to a wall box 1. If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in Figur e 2. Detach any RJ45 cables by unclippi…

3, AP-303H-MNTW Wall Mount Kit | Installation Guide 3 The wall mount contains two sets of holes to accommodate standard worldwide (Figure 3) and US (Figure 4) single gang wall boxes. The applicable standards for the wall boxes are:  Worldwide: IEC 60670-1, GB17466, BS4662, and DIN4…

4, Hewlett Packard Enterprise AP-303H-MNTW 4 AP-303H-MNTW Wall Mount Kit | Installation Guide 4. If available, route an Ethernet cable from the wall and connect to the PT port located on the back of the access point Mounting the access point 5. (Optional) If there are any additional wires that are left unused for this in…

5, AP-303H-MNTW Wall Mount Kit | Installation Guide 5 Figure 6 Mounting the 303H access point Access Point 7. Once the access point is attached to the wall mount, insert the security screw into the hole locate d on the right side of the mount and tighten. 8. Connect Ethernet cable(s) to the…