Heusinkveld Sim Pedals Sprint Product Manual

7, Mounting the pedals Each pedal is equipped with four mounting slots, allowing forwards and backwards adjustments to be made for optimal ergonomics. The bolt size for these slots is M5 (5mm). The width of the throttle and clutch pedal is identical, the brake pedal is a bit wider. For referen…

17, Heusinkveld Sim Pedals Sprint Throle - pedal force curve In the arm of the throttle pedal you’ll nd an adjustment to (mainly) change the slope of the pedal force curve. In the highest position, you’ll need more force to reach the end of pedal travel compared to the lowest setting. It also slightly raises t…

5, Step 2: Remove the nut and ring from the bolt. Do not remove the bolt yet. Step 3-4: Insert adjustment tool and push out the bolt. Do not remove tool. Step 1: Remove preload from the rubber stack (turn lock nut and knurled nut) Step 7: Adjust other foot with bolt partially in place.…

4, Adjusting the angle of the brake pedal The angle of the brake is adjusted as follows: 1. Remove all preload on the rubber stack. First you need to turn the lock nut towards the pedal arm, using the supplied wrench. Then you turn the black knurled adjustment nut towards the pedal arm…

15, Step 2: Use the wrench to lock the rear nut, insert the hex key. Step 4: Rotate the pedal plate 180 degrees. Pedal plate heigth adjustment overview. Step 3: Loosen the nut and bolt so the pedal plate can rotate. …

23, Clutch - pedal force curve In the arm of the clutch pedal you will nd an adjustment to change the slope of the pedal force curve. In the highest position, you’ll need more force to reach the end of pedal travel compared to the lowest setting. There are 3 possible settings. By default, the…