JETI model Max BEC 2D Manual 

2, 2.2 Magnetic Switch The magnetic switch is used to switch the BEC on or off. The switch consists of a switch-plate, which receives the magnetic key and also the magnetic key itself. The switch-plate is connected to the BEC by a three-wire cable and features two LED's. The gr…

1, 1. Introduction The Max BEC 2D is a linear voltage regulator, to provide power for the receiver and servos used in your models. For increased safety and reliability of this device, a magnetic switch is used to switch the unit on and off. The Max BEC 2D is fully compatible with th…

8, • Using the Jeti Box terminal, navigate to the Output (x.x) Volt setting (See section 4.3 SETTING - Configuration Options) and change to your desired value. This can be done in steps of 0.1V independently of the position of the short-circuit/jumper plug. The factory-default setti…

5, JETI model Max BEC 2D the sockets on the Duplex Expander. Connect the Expander to the Duplex Receiver into the socket marked 'Ext.'. Do not forget to connect the BEC to the receiver. Connect the power-supply battery to the BEC and connect the Jeti Box to the Transmitter module and switch-on the transmit…

6, voltage. Please note that these values are deleted automatically or can be deleted manually using the Erase Data menu option. The values are automatically erased when the unit is switched on and the input voltages exceed those specified in the Trigger Level menu option. Accum. A MIN/MAX - Sho…