iButton LinkHub-E Operation & User’s Manual

6, Key ~ (tilde) – Performs the same type of operation as the “j” key above except that power (strong pull-up) is applied to the bus after the first bit is issued. (Subsequent bits generated will not be followed by strong pull-up.) Key f – Performs a 1-Wire bus “firs…

13, Appendix C – Network Interface Notes The LinkHub-E Ethernet interface is implemented with a standard Lantronix XPort. More information and the Lantronix Device Installer may be downloaded from iButtonLink at http://www.ibuttonlink.com/manuals.aspx or from Lantronix at http://www.lantronix.c…

15, To use telnet configuration establish a telnet session to the LinkHub-E on port 9999. Press Enter for setup mode. Under Change Setup enter 1 for Channel 1 At Baudrate (xxxx)? enter 115200 Hit return to accept the current values until DisConnMode appears At DisConnMode (00) ? ente…

17, Copyright © 2008 by iButtonLink LLC iButton and 1-Wire are trademarks of Dallas Semiconductor Corp, Dallas, Texas, USA. 17 of 17 1 Channel 1 3 E-mail 5 Expert 6 Security 7 Defaults 8 Exit without save 9 Save and exit Your choice ? 1 Baudrate (9600) ? 115200 I/F…

8, Key \M (backslash uppercase M) – Set EEPROM Read/Write Address. The \M command is followed by a 6 digit Hex Address specifying the next EEPROM address to be read/written. Example: \M000030 would specify address 30 (hex) as the next read/write address. Key \m (backslash l…

4, iButton LinkHub-E LED indicators: The LinkHub-E has two LED indicators on the right side. The LED on the left is a heartbeat indicating that the LinkHub-E processor is running. While the processor is idle, the LED will illuminate at one-second intervals. The LED on the right indicates the prese…