Janome C30 Manual, Instruction Book

19, 17 CAUTION: Turn OFF the power switch before threading the machine. z x c v b z Draw the thread from the spool and pass it under the upper thread guide. e Upper thread guide Threading the Machine x While holding the thread near the spool, draw the end of the thread …

48, 46 Troubleshooting Condition Cause Reference The needle thread breaks 1. The needle thread is not threaded properly. 2. The needle thread tension is too tight. 3. The needle is bent or blunt. 4. The needle is incorrectly inserted. 5. The needle thread and bobbin thread are no…

14, Janome C30 12 Dropping or Raising the Feed Dog The drop feed lever is located lower part of the free arm bed on the front of the machine. To drop the feed dog, push the lever in the direction of the arrow q. To raise the feed dog, push the lever in the direction of the arrow w, as illustrated, an…

35, 33 Start sewing z Fold back the left seam allowance. Turn the right seam allowance under to form a 0.2 to 0.3 cm (1/8˝) margin. Place the zipper teeth next to the fold and pin in place. Set the stitch length and thread tension back to the original setting. q 0.2 to 0.3 cm (1…

30, 28 Memory Buttonhole q Stitch pattern: 17 w Thread tension dial: 1 to 4 e Presser foot: Sliding buttonhole foot 4 w eq z z Mark the buttonhole position on the fabric. Place the fabric under the foot with the buttonhole mark running toward you. Draw the needle thread to the le…

18, 16 Inserting the bobbin CAUTION: Turn OFF the power switch before inserting the bobbin and threading the bobbin holder. z Place a bobbin in the bobbin holder with the thread running off counterclockwise as shown on the hook cover plate. q End of thread w Bobbin …