HALE AP Technical Manual

3, i TABLE OF CONTENTS Section Title Page 1. SAFETY ............................................................................................................................................. 1 1.1. PPE ..................................................................................…

80, 68 Perform the following to remove and replace the suction head. NOTES Remove any suction tube and/or piping blocking access to the pump per OEM/equipment manufacturer instructions. Remove any discharge piping blocking access to the pump per OEM/equipment manufacturer inst…

61, 49 5.6. Miscellaneous Maintenance Miscellaneous maintenance consists of procedures to replace pump and/or gearbox compo- nents that typically do NOT fail under normal operating conditions. The procedures cover all ma- jor components that typically constitute a complete overhaul of the pump.…

171, C-9 C.3.3.3 ESP Primer Maintenance The Hale ESP primer (see Figure 60) is relatively maintenance free. If after testing the primer fails to pull 22 (± 2) inHg of vacuum one of the following may be the cause. • Vanes may be worn (require replacement) • Seals/O-rings may be …

150, HALE AP 138 d) Release and remove snap ring pliers. e) Verify retaining ring is seated in groove. NOTES The notch in the spacer faces the pump gear. The 3.74:1 GR configuration spacer does NOT have a notch. For ONLY 1.90, 1.64, 1.31 and 1.14:1 gear ratio pumps, install pump 2. gear. a) …

19, 7 2. INTRODUCTION This section provides an overview of the Flex series pumps, drives, and their options. Additional- ly, the section provides how to use this manual and principles of operation (including an explana- tion of terms and standard components). 2.1. Overview Hale Produc…