Glitch'd Gaming GG AIO Quick Start Manual

12, P a g e | 12 References: 1) Adafruit I2S Audio: https://learn.adafruit.com/adafruit-max98357-i2s-class-d-mono- amp/raspberry-pi-usage 2) HoolyHoo Battery Monitor Github: https://github.com/HoolyHoo/gbzbatterymonitor 3) GG AIO Board: http://glitchdgaming.com/index.php/…

6, P a g e | 6 B.Software The pi must be set-up to use I2s audio. Luckily, setting up is very trivial as Adafruit provides exactly what is needed. The following section is taken directly from Adafruit’s instruction page on their I2s amp, all credit belongs to them and Pimo…

5, Glitch'd Gaming GG AIO P a g e | 5 Next, attach your volume wheel. A mono 3 wheel pot is recommended. Wire the pins to the pads labeled “1,2,3”, next to the I2S GPIO pads. Wire them to the 3 pin wheel in the same order as the pads: center pad goes to center pin, side pads go to side pins. Depending on the…

2, P a g e | 2 Table of Contents Section Page Wiring Diagram Audio Hardware Software USB Pi Input External Port Power Main Power Battery Monitor (optional) Shoulder Buttons (optional) Analog Stick (optional) References 3 4 4 6 7 7 …

10, P a g e | 10 ./Install.sh Afterwards, do a sudo reboot to reset the pi and script should be running on boot up if everything was done correctly. If there are issues, you can install the script manually by following the link provided to HoolyHoo’s GitHub page and follo…