Avital 3100 Installation Manual

13, Avital 3100 © 2000 Directed Electronics, Inc. Vista, CA 13 Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash- board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK can be directly connected to the wire in the …

10, 10 © 2000 Directed Electronics, Inc. Vista, CA remote start ribbon harness wiring diagram ______ ______ ______ ______ ______ heavy gauge relay satellite wiring diagram ______ ______ ______ ______ ______ ______ remote start harness (H2) wiring diagram ______ ______ ______ ______ ______ _____…

33, © 2000 Directed Electronics, Inc. Vista, CA 33 features menu The factory default settings are indicated in bold text in the table below. feature descriptions 1 ENGINE CHECK ON/OFF: In the default setting the remote start will monitor either the vehicle's tach wire or voltage depending…

24, 24 © 2000 Directed Electronics, Inc. Vista, CA Interfacing with a reversing polarity system requires either two relays or one 451M (not included). It is critical to identify the proper wires and locate the master switch to interface properly. Locate wires that show voltage on lock and…

6, 6 © 2000 Directed Electronics, Inc. Vista, CA finding the wires you need IMPORTANT! Do not use a 12V test light or logic probe (computer safe test light) to locate these wires! All testing described in this manual assumes the use of a digital multimeter. We recommend two possible sou…

29, © 2000 Directed Electronics, Inc. Vista, CA 29 internal programming jumper NOTE: The control module door must be removed to access the jumper. In most cases, this jumper can be left in the OFF position. Some new vehicles use less than 12 volts in their igni- tion systems. The unit …