B&K AVR515 Operation & User’s Manual

27, SETUP SPEAKERS 1. Speaker Size The speaker setup menu defines how many speakers are installed in the system, the relative size of the speakers, and their location in the room. This is the most important setup procedure that will be performed. The receiver comes from the factory set…

37, 35 DSP Usage This screen monitors the amount of processing power being used. Expressed in MIPS (Millions Instructions per Second) Security Options In the security menu, the user can protect the receiver from accidental changes to unit settings or reprogramming. Changes made to the securi…

38, RS-232 Control Port The RS-232 port refers to the main RJ-45 connection located on the receiver's back panel. The RJ-45 contains connections for transmission and reception of RS-232 data. See pin-out at right. The RJ-45 also supports power supply and IR input for CK1.2 Keypad …

26, SYSTEM SETUP 1. Setup Speakers This menu configures the receiver for the number of speakers, speaker size, and location of the speakers in the room. It also contains room equalization options that can optimize the sound for a particular room. The overall sound quality of your system will depend upo…

23, B&K AVR515 KEYPAD CONNECTION DESCRIPTION To connect a CK1.2 Keypad to the AVR515 Series2 or 517 Series2, run a straight through Category 5 (CAT5) cable from the keypad location to the RS-232 jack on the receiver back panel. Terminate both ends of the CAT5 cable into RJ-45 using the T568B standard…

46, The following tables represent a visual synopsis of how the front will respond depending on the audio mode, number of speakers and the audio signal type. The first table shows how the front panel will display multi- channel digital bitstreams. The second table shows how the front …