Baby Lock embellisher EMB12 Instruction And Reference Manual

7, 4 3. Remove and replace Finger Guard Finger guard is a safety device to reduce risk of injury. If you would like to remove finger guard, special care is required around the felting needles. To remove finger guard: To replace finger guard: a) Open the lamp cover. b) Loosen the scre…

4, 1 Cloth presser height adjusting screw Handwheel Yarn & ribbon guide Ribbon guide Yarn port Power switch Yarn threader Yarn stand Yarn stand pin Washer Wing nut Socket for foot controller Sewing table Yarn Stand components Accessory storage Ribbon slot Needle plate Cloth press…

13, 7. Maintenance Changing the Needle(s) Note: #365A017 needle is a very special needle and is exclusive for the Embellisher machine. See your Baby Lock retailer for replacement needles. Caution: When changing needle(s), unplug the power cord from the electrical outlet. 1. Open lamp cover and…

14, Baby Lock embellisher EMB12 7. Maintenance Cont. Replacement of light bulb Swing the lamp cover towards the left to open. Remove the light bulb and replace with new one that is the same type rated 15 watts/120 volts or 15 watts/230 volts. ATTENTION: To prevent possibly injury, unplug main power cord prior to replacing lig…

9, 4. Start Embellishing cont. Layer the cloth/fabric/materials that will be felted together to create the embellishment. Make sure the smaller piece to be felted is on the correct side of the project. NOTE:Depending on the look you want to achieve this can be either right or wrong side of project. …