Bay Networks 5399 Manual 

241, A-51 Appendix A RAC Parameters Managing Remote Access Concentrators Using Annex Manager input _ flow _ control specifies the method of flow control for input received from a device connected to a serial port. You can enter: • none to disable flow control. • start/stop to designate flow…

175, Bay Networks 5399 8-1Managing Remote Access Concentrators Using Annex Manager Chapter 8 Configuring Modems This chapter describes how to: • Change the definition of an existing modem for any RAC • Create a new modem definition or remove modem definitions for RACs other than ISDN Primary Rate RACs • …

135, 5-5 Chapter 5 Booting and Resetting RACs Managing Remote Access Concentrators Using Annex Manager • Abort cancels all delayed boot requests. • Quiet boots the RACs you selected without sending a warning message to users. • Save In Flash loads the boot image and saves it in flash memory.…

26, Managing Remote Access Concentrators Using Annex Manager Chapter 1 Starting Annex Manager 1-6 information, you can use Setup windows and other Annex Manager commands. The Main window displays at all times when you use Annex Manager. In Customize mode, you can return to this wi…

154, Managing Remote Access Concentrators Using Annex Manager Chapter 7 Configuring RAC Parameters 7-6 7. Click Close to return to the Main window. Viewing and Changing Parameter Values This section describes how to view and change individual RAC parameter values. Viewing Parameter Va…

226, Managing Remote Access Concentrators Using Annex Manager Appendix A RAC Parameters A-36 CallDef_term_var identifies the type of terminal dialed in to a RAC or an ISDN Primary Rate RAC via a CLI connection. You must enter a valid terminal type for the host. The RAC passes the t…