Belling BI 70 G and User Manual And Installation

19, Belling BI 70 G and 17 Programmer / Clock The clock on this product has two modes of operation, fully automatic or semi-automatic. This product is intended for use on the semi automatic mode only. If for some reason this mode has not already been pre-set, the following procedure should be used to set …

34, Method 3: Housing unit with internal height 710mm or more Note: You will not need the 4 runners and 2 trims that are packed with the oven for this installation. Remove any fixings that may prevent entry of the oven into housing, or obstruct the gas inlet pipe. The cabinetry should be kept struct…

2, The appliance must be installed (and serviced) by a GAS SAFE registered approved installer or a person competent to ensure that the installation is in accordance with “The Gas Safety (Installation and Use) Regulations 1994”, and the “The Gas Safety (Installation and Use) (Amendm…

18, Using the Ovens 16 Semi-Automatic cooking in the main oven The semi-automatic cooking facility is controlled by the programmer (see ‘Programmer/Clock’ section) and allows for the finish time to be set. If you know the cooking time of the dish that you are cooking, you can set this and the oven…

11, 9 Using the Ovens Using the top oven The top oven can be used in the same way as the main oven to cook a full range of dishes, however it is a secondary oven and there are some differences. The top oven cavity is smaller in size and therefore better suited to smaller dishes and food portions. …