BENDIX COMPACT 500 Manual 

4, BENDIX COMPACT 500 4 FIGURE 2 SEAL AND GLIDE RINGS SPINDLE ASSEMBLY W/ ROTARY VALVE (BALL SCREW ASSEMBLY) DELIVERY FROM ROTARY VALVE OIL OUT INPUT SHAFT VALVE NUT BY PASS VALVE CIRCULAR GROOVES OIL IN ROTARY VALVE SUPPLY OUTPUT SHAFT PISTON OIL PASSAGE DRAIN PLUG FIGURE 3 MECHANICAL- HYDRAULIC…

25, 25 A. Gauge pressure should read the same as the power steering pump relief pressure. (See Step 1 under Relief Pressure Test - Power Steering Pump) B. With system pressure at pump relief, read the flow meter. If a flow greater than 3.5 quarts per minute is noted, internal leakage is excessive …

24, 24 PART NUMBER 106773 PRESSURE RELIEF VALVE TEST PLUG ASSEMBLY FIGURE 50 2. Allow the power steering pump fluid to cool to 130°F before testing is resumed. 3. With the engine at full governed R.P.M. close the shutoff valve and note that the flow reads 0. QUICKLY OPEN THE SHUTOFF VALVE, a…

15, 15 17. Remove the inner O-ring(17) and the nylon seal ring(18) from the valve body(16). NOTE: Do not remove the inner ball race(28) from the valve body(16) if it is in good condition. 18. Then remove the dust seal(13), snap ring(14) and the seal(15) from the valve body(16). (See Figures…

18, 18 FIGURE 36 FIGURE 35 Without removing tool 297676, insert the nut(33) into the valve body(16), screw and tighten it to a torque of 330 ft. lbs. with a spanner wrench. (See Figure 35) NOTE: Tool 297676 for the teflon glide rings will come out as the nut is screwed into the valve…

19, 19 FIGURE 38 Insert the 19 balls (29) one by one in one of the openings for the recirculating tubes located in the piston (48) while turning the spindle at the same time. Balls inserted in one opening should recirculate to the opposite opening as the ball screw is rotated. Before proceedi…