Billion BiPAC 7800 Operation & User’s Manual

63, 59 ARP This table stores mapping information that the device uses to nd the Layer 2 Media Access Control (MAC) address that corresponds to the Layer 3 IP address of the device via the Address Resolution Protocol (ARP) feature. IP Address: Shows the IP Address of the device tha…

143, Billion BiPAC 7800 139 IGMP IGMP, known as Internet Group Management Protocol, is used to manage hosts from multicast group. IGMP Proxy: IGMP proxy enables the system to issue IGMP host messages on behalf of the hosts that the system has discovered through standard IGMP interfaces. The system acts as …

65, 61 System Log Display system logs accumulated up to the present time. You can trace its historical information with this function. Refresh: Click to update the system log. Clear: Click to clear the current log from the screen. …

44, 40 Basic Conguration Mode Status Device Information Model Name: Provide a name for the router for identication purposes. System Up-Time: Record system up-time. Hardware Version: Device version. Software Version: Firmware version. Port Status Port Status: User can look up to se…

77, PIN Method: Congure AP as Enrollee 1. In the WPS conguration page, change the Role to Enrollee. Then press Start. 2. Jot down the WPS PIN (eg. 25879810). 3. Launch the wireless client’s WPS utility (eg. Ralink Utility). Set the Cong Mode as Registrar. Enter the PIN number in the P…

145, 141 Remote Access Remote Access Control: Select Enable to allow management access from remote side (mostly from internet). "Allowed Access IP Address Range" was used to restrict which IP address could loggin to access system webGUI. Valid: means to enable the IP address Ran…