Biostar U8598 Operation & User’s Manual

52, Mainboard Features 49 Step 4: Install PAM Utility PAM (Promise Array Management™) Installation This section outlines the installation procedure for a component of the PAM software package. NOTE : If you are re-installing PAM, you must first …

36, Biostar U8598 Mainboard Features 33 6-6-1. CD-ROM Audio-In Header: JCDIN1 Pin No. Assignment 1 Left Channel Input 2 Ground 3 Ground 4 Right Channel Input 6-6-2. CD-ROM Audio-In Header: JCDIN2 (Optional) Pin No. Assignment 1 Left Channel Input 2 …

51, Mainboard Features 48 Removing the Driver from Windows NT 4.x 1. In “Start” Button choose “Control Panel” in “Setup” group. 2. In “Control Panel,” select “SCSI Adapter,” next choose “Drivers” label 3. Choose “Remove” button. …

49, Mainboard Features 46 Windows NT4 Installing Drivers During Windows NT 4.0 Installation 1. Start the system installation by booting from the Windows NT disk: a) Floppy install: boot the system with the FastTrak 376 driver diskette. b) Fl…

55, Mainboard Features 52 Select Program Folder Window 8) The “Start Copying Files” window will then be displayed. Verify that the proper component(s), destination folder, and program folder you selected for installation are correct, then click on the “N…

60, Mainboard Features 57 An Array” on page 45. To rebuild a mirrored array, see “Rebuilding an Array” on page 47. NOTE : After configuring an array using FastBuild™, you should FDISK and format the arrayed drive(s) if you are using new, blank drives.…