Bissell LIGHTWEIGHT 3120 Operation & User’s Manual

12, 12 www.bissell.com Warranty This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact us by E-mail, telephone, or…

7, 1. Turn off vacuum and unplug it from electrical outlet. 2. Remove dirt cup by pulling the dirt cup release handle then lift dirt cup out. 3. Grasp the lower tank located at the bottom of the dirt cup and twist to unlock and remove. 4. Grasp the circular filters and twist to unlock. Pull st…

10, 10 www.bissell.com 800.237.7691 Replace drive belt 1. Follow steps 1-4 of previous section, “Clean and replace rotating floor brush”. 2. Check drive belt carefully for wear, cuts and stressed areas. If the drive belt appears worn, you will need to replace it. 3. Grasp old dri…

11, 11 www.bissell.com 800.237.7691 Troubleshooting Vacuum cleaner won’t run Possible causes Remedies 1. Vacuum cleaner is not plugged in 1. Check electrical plug 2. Household fuse/breaker 2. Check/replace fuse or reset breaker Vacuum cleaner won’t pick up dirt Possible causes Remedies…

6, Bissell LIGHTWEIGHT 3120 How to maintain your Vacuum To maintain maximum cleaning performance, the following maintenance steps must be performed: 1. Clean the dirt tank if any visible clogs occur. 2. Empty the dirt cup when the dirt reaches the “Full” line on the side. 3. Check the inner and outer circu…

8, 8 www.bissell.com 800.237.7691 Cleaning the pre-motor filter The pre-motor filter protects the motor from debris. It is the small, round filter located underneath the dirt cup, right above the motor. 1. Unplug the cleaner from the electrical outlet. 2. Remove dirt cup by pulling the dirt cu…