BIXOLON SRP-275 Operation & User’s Manual

39, Rev. 2.00 - 39 - SRP-275 Ver.2 11-3 The printer stops printing • If the ERROR LED is on (but not blinking), the printer is off line. Check to see that the covers are closed and check the paper state. See Chapter 5 for instructions on installing or replacing the paper roll. • If…

23, BIXOLON SRP-275 Rev. 2.00 - 23 - SRP-275 Ver.2 • Default Settings The default settings for Memory Switch 0 to Memory Switch 8 are shown below. Settings vary for single byte character countries (standard specifications (SBCS)) and for double-byte character countries (Chinese character specific…

2, Rev. 2.00 - 2 - SRP-275 Ver.2 ■ Safety Precautions In using the present appliance, please keep the following safety regulations in order to prevent any hazard or material damage. WARNING Violating following instructions can cause serious injury or death. Do no…

9, Rev. 2.00 - 9 - SRP-275 Ver.2 1-3 Using the operation panel Most of the functions of this printer are governed by software, but you can monitor the printer s status by looking at the lights on the control panel and for some procedures you will use the buttons. • Contr…

32, Rev. 2.00 - 32 - SRP-275 Ver.2 8. Self Test The self test let you know if your printer is operating properly. It checks the printing quality, ROM version, DIP Switch settings, memory switch settings and statistic data. The test is independent of any other equipment or software, so it …