Clifford Matrix RS2 Installation Manual

28, 28 © 2001 Directed Electronics, Inc. 4. TTrraannssmmiitt.. While HOLDING the Valet/Program switch, press the button from the transmitter that you wish to assign to that channel. The unit will chirp indicating that the channel has been entered. 5. CCoonnffiirrmm.. While still HOLDING the…

26, Clifford Matrix RS2 Door Lock Harness (H4) Wire Connection Guide ___ ___ ___ For detailed instructions on wiring the vehicle’s door locks, please refer to the Door Lock Wiring Guide ( DDooccuummeenntt NNoo.. 11004411 ) provided on the wwwwww.. ddiirreecctteecchhss..ccoomm website or through DDiirreecc…

11, www.clifford.com 11 H1/8 BLACK (-) Chassis Ground Connection Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than your own screw. (Screws tend to either strip or loosen with time.) We recommend grounding all your components, including the sire…

36, 36 © 2001 Directed Electronics, Inc. Feature Menu 2 - Advanced Features 2-1 SIREN OUTPUT CONSTANT/PULSED: The system can be programmed to output pulses instead of a continuous output when the system is triggered. This is useful to honk the factory horn in applications where a siren is undesirabl…

12, 12 © 2001 Directed Electronics, Inc. Auxiliary Harness (H2) Wire Connection Guide ___ ___ ___ H2/1 GRAY/BLACK (-) Diesel Wait-To-Start Bulb Input Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dashboard. In most diesels the wir…

18, 18 © 2001 Directed Electronics, Inc. connected, you must teach the system the tach signal. (See the Programming Jumpers section of this guide.) H3/6 BLACK/WHITE neutral safety switch input Connect this wire to the provided toggle (override) switch as shown in figure A. Connect the othe…