Bryant 558D Installation, Start-up And Service Instructions Manual

6, IV. FIELD CONNECTIONS A. External Trap Condensate Drain The unit’s 3 ⁄ 4 -in. condensate drain connections are located on the bottom and side of the unit. Unit discharge connec- tions do not determine the use of drain connections; either drain connection can be used with vertical…

2, *Indicates horizontal center of gravity. †Indicates vertical center of gravity. NOTES: 1. Dimensions in [ ] are in millimeters. 2. Center of gravity. 3. Direction of airflow. 4. Ductwork to be attached to accessory roof curb only. 5. Minimum clearance (local codes or jurisdict…

40, START-UP CHECKLIST (Remove and Store in Job File) I. PRELIMINARY INFORMATION MODEL NO.: DATE: SERIAL NO.: TECHNICIAN: II. PRE-START-UP (insert checkmark in box as each item is completed) M VERIFY THAT CONDENSATE CONNECTION IS INSTALLED AS SHOWN IN THE INSTALLATION INSTRUCTIONS M CHECK A…

30, IV. REFRIGERANT CHARGE Amount of refrigerant charge is listed on unit nameplate (also refer to Table 1). Unit panels must be in place when unit is operating during charging procedure. This unit uses a fixed-orifice refrigerant metering device lo- cated in the coil header. There is …

26, Bryant 558D Table 16 — 558D060 Air Delivery — Horizontal Discharge Units (Standard Motor) AIRFLOW (Cfm) STANDARD DIRECT DRIVE MOTOR Low Speed Medium Speed High Speed 208 v 230, 460, 575 v 208 v 230, 460, 575 v 208 v 230, 460, 575 v ESP Watts ESP Watts ESP Watts ESP Watts ESP Watts ESP Watts 1500 1…

28, Whenever the evaporator fan is energized (during heating, cooling or continuous fan), 24-v power is on terminal IFO on the economizer or two-position damper control board. The damper motor will be energized with 12-vdc power and the damper will drive open until SW3 on the damper is deacti- vated. …