Bulldog Security Deluxe 62 Installation And Owner's Manual

5, 4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. 3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the left wire as shown. 2. Twist upper wires together, t…

13, Bulldog Security Deluxe 62 Programming Shock Sensor On and Off (See Adjusting Shock Sensor) Press and hold the brake, then press and hold Button #4 (stop) until the parking lights flash four (4) times. Release Button #4. Press and release Button #2, the parking lights will flash once the shock sensor is now ON. Pres…

11, HOW TO USE YOUR REMOTE TRANSMITTER 10 CONNECTING DOOR LOCKS “Type A” (+) Positive (5-pin harness) NOTE: Connect the RED WITH BLACK STRIPE wire to +12V constant fused at 30 amps. UNLOCK LOCK GREEN/BLACK Unlock GREEN/WHITE Not Used RED/BLACK BLUE/BLACK Lock BLUE/WHITE Not Used K…

7, 6 HOOD PIN SWITCH This feature will keep the engine from starting or shut off the engine when the hood is opened. Locate a good chassis ground, if at all possible do not install the pin switch in the rain gutter. Drill a 5/16 hole, insert the pin switch into the hole and tighten. Check for …

10, FACTORY ANTI-THEFT SYSTEMS FOR GENERAL MOTORS CARS ONLY System 1: PASSKEY I and II system (1985 and up). This system has a resistor pill in the key. Measure resistance of the pill using a test meter. A bypass module is available, part #VATS-WR module. System 2: PASSLOCK I and II system (1995 and u…