Bunn IMIX IMIX-3 Installation & Operating Manual

4, 4 INITIAL SET-UP 1. Apply the four non-skid pads from the parts box to the bottom of the legs. 2. Remove the drip tray assembly, drip tray bracket, and splash panel assembly from the parts box. 3. Place a set of key holes in the drip tray bracket over the lower two screws in the panel b…

13, 13 PROGRAMMING THE DISPENSER (cont.) LOW POWDER LOCK ? NO EXIT YES DISPENSE LOCKOUT NO EXIT YES RINSE ALARM ? NO EXIT YES HEAD 1 DISABLE ? NO EXIT YES SET PASSWORD ? (-) XXXX (+) Returns to (G) (page 11) TEST SWITCHES ? Use Switch To Test TEST HEATER ? …

12, 12 XX°CALXX° (-) Tank Temp (+) PROGRAMMING THE DISPENSER (cont.) DRINK STRENGTH 1 (-) XX (+) PRESS DISPENSE TO CHECK TASTE TASTE 1 OK ? NO YES SET FLAVOR 1 BY TASTE RECIPE ENTER RECIPE # #.# gm/fluid oz CHANGING VALUE…

1, IMIX ® -3 IMIX ® -4 IMIX ® -5 INSTALLATION & OPERATING MANUAL BUNN-O-MATIC CORPORATION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 www.bunnomatic.com 37510.0000E 09/07 ©2004 Bunn-O-Matic Corporation To obtain the Illustr…

6, Bunn IMIX IMIX-3 6 INITIAL fill & heat 1. Turn on the water supply and connect the dispenser to the power source. 2. Water will automatically flow into the tank to the proper level and then shut-off. This will take less than ten minutes. 3. When the tank is full of water, open the fro…