Bunn IMIX-14 Installation & Operating Manual

14, 14 PROGRAMMING THE DISPENSER (Cont.) TANK TEMP ###° READY TEMP ###° (-) EXIT (+) DRINK STRENGTH 1 (-) EXIT (+) (-) ### (+) ENTER PASSWORD (-) 0 (+) CALIBRATION ? EXIT YES LOCKS/DISABLES ? EXIT YES AUDIBLE ALARM ? NO EXIT YES ENTER ASSET # ? EXIT YES ENAB…

6, 6 ELECTRICAL REQUIREMENTS WARNING - If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with a special cord available from the manufacturer or its service agent in order to avoid a hazard. CAUTION - The dispenser must be disconnected fro…

7, 7 PLUMBING HOOK-UP 1. Flush the water line and securely attach it to the elbow fitting on the bottom of the dispenser. 2. Turn-on the water supply. This equipment must be installed to comply with the International Plumbing Code of the International Code Council and the Food C…

8, Bunn IMIX-14 8 INITIAL FILL & HEAT 1. Turn on the water supply and connect the dispenser to the power source. 2. Water will automatically flow into the tank to the proper level and then shut-off. This will take less than ten minutes. 3. When the tank is full of water, open the front door and pla…

9, 9 POWDER PRODUCT STRENGH ADJUSTMENT The strength of the individual powdered beverages can be adjusted by changing the hopper motor speed. See menus under “DRINK STRENGTH #” in the program menus to adjust the hopper dispense rate for each hop- per. DRAINING THE HOT WATER TANK CAUTION …

12, 12 PROGRAMMING THE DISPENSER (Cont.) BEVERAGES The IMIX-14 unit has 15 dispense switches. PROGRAMMING SWITCHES Using the menu-driven display (Touch Screen) on the front of the dispenser, the operator has the ability to alter or modify various functions of the dispenser. This allows…