Bush Hog 3545 Operator's Manual

33, SAFETY DECALS To promote safe operation, Bush Hog supplies safety decals on all products manufactured. Because damages can occur to safety decals either through shipment, use or reconditioning, Bush Hog will, upon request, provide safety decals for any of our products in the field at no c…

40, Page 6 17. NOTE: This valve is set for a open center tractor hydraulic system. If tractor has a closed center system a closed center plug must be installed. Remove the open center plug in valve. Install the closed center plug furnished with the valve (Refer to Fig. 6). 18. Tighten all fit…

27, Bush Hog 3545 TABLE 4-1 TROUBLESHOOTING PROCEDURES PROBLEM POSSIBLE CAUSE REMEDY Loader slow and/or will not dump. Hydraulic oil viscosity too heavy. Change to proper oil. Oil filter plugged. Clean or replace filter. Hydraulic pump worn. Repair or replace pump. Oil line restricted or leaking. Check all ho…

25, SECTION IV MAINTENANCE 4-1 MAINTENANCE CHECK LIST Perform scheduled maintenance as outlined below. Lower machine to ground, turn off tractor, and set parking brake before doing maintenance inspections or work. All bolts should be torqued as recommend- ed in torque chart unless otherwise indicated. …

16, 3-4 EXTERNAL LOADER AND/OR TRAC- TOR VALVE. NOTE When properly installed, the tractor remote valve or external valve control lever/levers will control the loader hydraulic circuits as described below. Refer to tractor Operator’s Manual for further explanation of tractor remote co…

29, 5-2 TRACTOR BALLAST Tractor weignt bracket may be left in place on cer- tain tractor models with loader mounted. Front trac- tor weights can only be used when the loader is parked. Weights must be removed before remount- ing loader or serious damage will occur to loader or tracto…