Specifications:84/84181-w251i_installation_and_operation_instruction.pdf file (02 Oct 2023)
|
Byron W-251i Accessory PDF Installation And Operation Instruction (Updated: Monday 2nd of October 2023 11:30:41 AM)
Rating: 4.4 (rated by 71 users)
Compatible devices: SX-60i, SX-21, DB305, SX210i, SX-86, BY103, SX-15i, BY101.
Recommended Documentation:
Door Chime • Remove the front cover. • Insert 3 x 1.5volt alkaline batteries (“C”, UM2 & LR14 - not included) into the battery compartment, ensuring the battery polarity match the internal markings. • Snap the front cover back on then it is ready to use. IMPORTANT: Not to be used with a transformer. 1 UM2 R14 “C” UM2 R14 “C” UM2 R14 “C” UM2 R14 “C” UM2 R14 “C” UM2 R14 “C” Wired Door Chime with Light W-251i Wired Door Chime with Light W-251i 75m 6 Byron No.W251 Size: A4 Date: 10 Nov 2007 Digital Code Set Up • Press the Wired Push Button once, the Wired Chime unit will sound and it will generate a new operation code randomly and send a wireless signal to the Wireless Chime unit. • The Wireless Chime unit will sound to indicate that new operation code is registered and memorised. 4 Wired Door Chime Wire Installation • Run a length of bell wire from the bell push terminals to the location you wish to mount your chime. • Split the wires and bare the end of the wire. • Connect the wire to the terminal block in the top right corner of the chime. • Push down the brown tab on the top of the terminal by a small, flat screwdriver. • Whilst the tab is pressed down, insert your bell wire. • One wire into the blue terminal, the other wire into the red terminal. 2 Important 1. Do not mount the Chime unit close to fireplace or expose to high temperatures. 2. Do not expose the Chime unit to direct sunlight or moisture 3. Always use alkaline battery. Please dispose of old, defective batteries in an environmentally friendly manner in accordance with the relevant legislation. 4. Make sure that no naked flame sources, such as lighted candles, should be placed on the unit. 5. The unit should not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the unit. 6. CAUTION: Replace only with the same or equivalent type of battery that is recommended by the manufacturer. 7. CAUTION: Make sure batteries are installed correctly as per the internal markings. 8. CAUTION: Danger of explosion if battery is incorrectly installed or replaced. 9. IMPORTANT: There are no serviceable parts in the units, do not attempt to repair it. User Hints If the door chime unit does not sound, please check the followings: a) Flat batteries in either Wired or Wireless Chime units - change the batteries. b) Wrong battery polarity in either Wired or Wireless Chime units - re-insert the batteries. c) Wired and Wireless Chime units are not on the same operation codes - re-set the code (see digital code set up). d) Units are out of range - Operate the Chime unit within the operation range. Specification Operating Temperature: -10C - +40C Operating Distance : 75metre (245ft approx. - in open field & at suitable condition) Selectable Digital Code: Total two hundred fifty six (256) possible digital codes “Type R2 Device - device where the sound output is created by the initial operation of the control and where the period of sound output continues for the designed duration irrespective of condition of the control.” 433MHz R&TTE APPROVED CH Byron Electrical United Kingdom. www.chbyron.com CH Byron Electrical Ltd Byron House 34 Sherwood Rd, Astonfield Bromsgrove, B60 3DR UK Tel: 0845 2301231 e: [email protected] w: www.chbyron.com Door Chime unit Power: 3 x 1.5volt alkaline batteries (“C”, UM2 & R14 - not included) Wired Door Chime Wire Installation 1. Run a length of bell wire from the bell push terminals to the location you wish to mount your chime. 2. Split the wires and bare the end of the wire 3. Connect the wire to the terminal block in the top right corner of the chime. 4. Push down the brown tab on the top of the terminal by a small, flat screwdriver. 5. Whilst the tab is pressed down, insert your bell wire. 6. One wire into the blue terminal, the other wire into the red terminal. Operate With A Byron SX Range Wireless Door Chime The Chime unit can be operated with the Byron SX Range Wireless Door Chime. When the wired chime unit is activated, it sends a wireless signal to your Wireless Door Chime that activates the chime to sound, with the operation range up to 75m (245ft approx. - in open field & at suitable condition). Read the following instructions before use. Digital Code Set Up The Chime unit is equipped with an advanced random and self-learning operation coding ability therefore no setting is needed. Read the following instructions before use. 1. First time operation: After battery installation on both Wired and Wireless Chime units, press the wired Push Button once, the Wired Chime unit will sound and it will generate a new operation code randomly and send a wireless signal to the Wireless Chime unit. The Wireless Chime unit will sound to indicate that a new operation code is registered and memorised. 2. Interference from a similar unit operating nearby: a) Simply remove the batteries from both Wired and Wireless Chime units and rest for 10 seconds, this will erase the memory. a) Insert the batteries into the Wired and Wireless Chime units. Press the wired Push Button once, the Wired Chime unit is sound and it will generate a new operation code randomly and send a wireless signal to the Wireless Chime and it will sound to indicate that new operation code is registered and memorised. Melody Selection - Wireless Door Chime Press the melody selector once to select a melody as your wireless door chime sound, there is a total of 8 melodies for selection. Melody Selection • Press the melody selector once to select a melody as your Byron SX range Wireless door chime sound, there is a total 8 melodies for selection. 5 UM2 R14 “C” UM2 R14 “C” UM2 R14 “C” Melody Selector Door Chime Installation • Drill a hole, fit a wall plug and screw. • Leave a gap of 3mm between the screw head and wall. • Locate the keyhole slot on the back of the chime unit over the screw. 3 3mm Operation • Press the wired Push Button once, the wired chime unit is activated and sound, it also sends a wirless signal to your Wireless Door Chime, and your door chime will sound. • Operate the Wireless Door Chime unit within the operation range up 75m (245ft approx. - in open field & at suitable condition), test it before final installation. Flashing Light Operate With Byron SX Range Wireless Door Chime Operate With Byron SX Range Wireless Door ChimeOperate With Byron SX Range Wireless Door Chime
Intercom System KDP-601A Guide, #C2FGR9
KDP-601A, 2, kocom/kdp-601a.pdf
Z Systems Reference Book Stereo Equalizer z-Q6 Six-Channel (#N8DZHW)
z-Q6 Six-Channel, 10, z-systems/z-q6-six-channel.pdf
MCD-SM55 CD Player - #1997O7
MCD-SM55, 13, samsung/mcd-sm55.pdf
Lawn and Garden Equipment 917.28035 User Guide, #6Z26U5
917.28035, 64, craftsman/917-28035.pdf
User Manual (Dune Fighter, #3NZA78)
Dune Fighter, 124, reely/dune-fighter.pdf
TV DVD Combo Guide #FXXRKT
MWC13D5df, 40, funai/mwc13d5df.pdf
Dell Guidance Laptop Inspiron 24 3000 series (#3887Z1)
Inspiron 24 3000 series, 79, dell/inspiron-24-3000-series.pdf
Murphy Switch Manual (#26B2F8)
EVS-2, 24, murphy/evs-2.pdf
#F9Y61X: Telephones Document
Telephones, 26, marks-spencer/telephones.pdf
#ZM3G88: HR-9016 Turbo Tutorial
HR-9016 Turbo, 54, jacobsen/hr-9016-turbo.pdf
OPTIONAL ATTACHMENTS & ACCESSORIESAccessories90090 Driveshaft Assembly S/N: 05007797 -0599999999946400020 Power Pruner 5 Foot Orange ExtensionAttachments99946400040 Hedger Accessory99946400050 Power Pruner Circle Saw Accessory99946400060 Hedge Clipper AttachmentGuide Bars1080373301 Guide Bar - ...
Model & Doc Type: PPT-260 - PARTS CATALOG SERIAL NUMBERS 05001001-05999999 46
C U S T O M E R S E R V I C E A N D T E C H N I C A L S U P P O R T©2006 Niles Audio Corporation 12331 S.W. 130 Street, Miami, FL 33186. All rights reserved. Niles, the Niles logos and iWARE are registered trademarks of Niles Audio Corporation. SmartDock is a trademark ...
Model & Doc Type: Extender System iWare ES1 8
Product: Solar Accessory KitSunforce Model: 50056UPC Code: 787769500568Warranty: 1 yearManual and Parts list available: manualCountry of Origin: ChinaProduct Dimensions:(L x W x H) 8 1/8" x 6" x 2 1/4"20.5 x 15 x 6 cmProduct Weight: 1.7 lbsInner Pack Quantity: NAInner Pack Weight:Inn ...
Model & Doc Type: 50056 1
The Fluke Ti4x models feature everything needed for virtually every thermography task. With a 160 x 120 detector and a temperature sensitivity to 0.08 °C (NETD) they deliver high resolution images where even the smallest temperature differences can be seen. The units are extremely eas ...
Model & Doc Type: Ti40FT-20 2
# | Brand | Model | Document Type/File | Pages | File Size | Last Checked |
---|---|---|---|---|---|---|
1 | Sunforce | 85 WATT MONOCRYSTALLINE SOLAR PANEL |
54 | 19/01 | ||
2 | Phonak | iCom |
76 | 25/11 | ||
3 | Creative | TRAVELSOUND I85 |
1 | 4.97 Mb | 28/11 | |
4 | Sennheiser | IE 8i |
2 | 0.25 Mb | 27/03 | |
5 | Fluke | 725Ex |
65 | 27/01 | ||
6 | Whirlwind | W3 |
3 | 0.38 Mb | 21/04 | |
7 | Panasonic | WV-PB5508 |
4 | 0.21 Mb | 18/12 | |
8 | Windmere | Clothes Shaver |
1 | 0.65 Mb | 31/01 | |
9 | Lenovo | ThinkPad X130e |
192 | 02/01 | ||
10 | Nuface | trinity |
16 | 20/12 |
# | Brand | Model | Document (PDF) | Pages | Size | Check Date |
---|---|---|---|---|---|---|
1 | Canon | Laser Shot |
39 | 13.02.2024 | ||
2 | Nikon | D3 VBA18001 |
134 | 04.03.2024 | ||
3 | Renkforce | renkCast 2 |
52 | 31.12.2023 | ||
4 | Hantarex | MTC 900 |
23 | 24.12.2023 | ||
5 | Taurus | TF-RX7-2 |
80 | 13.01.2024 | ||
6 | Xerox | DocuColor 242 |
1161 | 20.54 Mb | 01.12.2023 | |
7 | Klarstein | 10008799 |
9 | 26.03.2024 | ||
8 | EMS | AirFlow Master |
40 | 02.01.2024 | ||
9 | GRASS VALLEY | 8910ADA-M |
58 | 28.02.2024 | ||
10 | Optimus | UP-127M4 |
14 | 05.11.2023 |