Cabletron Systems 6000 Operation & User’s Manual

195, Configuring BSC 9-21 Printer specifies whether the device has an attached printer. Disable Status Response determines how the BSC port will report the status of the attached device: 0 = Normal Status. The port will report what the device reports. 1 = No Status. The port will repo…

100, 6-18 FRX/FRM 3.3 User G uide, Rev 04 declared active after that poll. (If the N2 Error Threshold is exceeded during the N3 count, the DCE will be declared inactive, and the N3 count will be restarted.) T1 Link Integrity Timer determines how often the logical DTE will initiate a Statu…

110, 6-28 FRX/FRM 3.3 User G uide, Rev 04 cation.) If the Clear Retry Count expires, restart and recovery procedures should be ini- tiated. Closed User Group Parameters The CUG function is a privacy feature that allows creation of up to 100 groups of users per port. Members of a CUG can c…

200, 10-4 FRX/FRM 3.3 User G uide, Rev 04 0 = escape is not allowed. 1 = escape will be initiated by [Ctrl] [P] ( 1/0 ), Data Link Escape . 32–126 = escape will be initiated by the character defined by this number. 02, Echo provides for characters received from the user's…

94, 6-12 FRX/FRM 3.3 User G uide, Rev 04 Figure 6-6 Frame Relay DLCI Configuration Screen 1 Pressing [F4] at this or the subsequent screen (Figure 6-7) will delete the DLCI rate control and backup configuration. (The port will not be deleted unless [F4] is pressed at one of …

412, Cabletron Systems 6000 Glossary-10 FRX/FRM 3.3 User G uide, Rev 04 X X.3 is a CCITT recommendation that defines the service provided by an asynchronous PAD to connect a character-mode terminal to an X.25 network. X.25 is a CCITT recommendation that specifies the DTE/DCE interface for “packet mode” operatio…