Cabletron Systems 9000 Operation & User’s Manual

19, Cabletron Systems 9000 2-7 Installing the SmartSwitch 9000 Module The Reset Switch The Reset switch is located on the front panel, under the top plastic tab as shown in Figure 2-4. It serves two functions: • Pressing the reset switch twice within three seconds causes the processor (i960) to reset. �…

32, Specifications 5-2 Physical Dimensions 35.0 D x 44.0 H x 3.0 W centimeters (13.8 D x 17.4 H x 1.2 W inches) Weight Unit: 1.36 kg. (3 lb.) Shipping: 1.81 kg. (4 lb.) Electrical CPU: i960 Shared DRAM Memory: 12Mb (expandable to 32 Mb) Local DRAM Memory: 16Mb (expandable to 32 Mb)…

26, Operation 3-6 DC/DC Converter The DC/DC converter converts the 48 VDC on the system power bus to the necessary operating voltages for its host network services module. The diagnostic controller controls the operation of the DC/DC converter. FNB Interface SmartSwitch 9000 modules…

23, 3-3 Operation The second filtering process, the Cabletron Systems Special Filtering Database, provides an additional step in the filter/forward decision. Through Remote Management, you can define up to 10 additional filtering parameters for incoming network traffic. These parameter…

21, 3-1 Chapter 3 Operation The 9T125-08 MicroLAN Module provides connectivity between the front panel Token Ring(s) and the FDDI rings on the backplane (FNB-1 or FNB-2). SmartSwitch 9000 modules connect to either the Internal Network Bus (INB) or the Flexible Network Bus (FNB) bus. The 9T…