Cabletron Systems SMARTSWITCH ROUTER 9032578-05 User's Reference Manual

140, Chapter 11: OSPF Configuration Guide 114 SmartSwitch Router User Reference Manual Default Cost of an OSPF Interface The default cost of an OSPF interface is calculated using its bandwidth. A VLAN that is attached to an interface could have several ports of differing speeds. The bandwidt…

165, SmartSwitch Router User Reference Manual 139 Chapter 12: BGP Configuration Guide The following lines on the Cisco router set up IBGP peering with router SSR6. IBGP Internal Group Example The IBGP Internal group expects all peers to be directly attached to a shared subnet so that, like external pee…

49, SmartSwitch Router User Reference Manual 23 Chapter 3: Bridging Configuration Guide • Multicast based • Policy based Detailed information about these types of VLANs is beyond the scope of this manual. Each type of VLAN is briefly explained in the following subsections. Port-based VL…

372, Cabletron Systems SMARTSWITCH ROUTER 9032578-05 Chapter 25: WAN Configuration Guide 346 SmartSwitch Router User Reference Manual WAN interfaces, then apply a service profile to the desired interface(s). Examples of this process are displayed in “PPP Port Configuration” on page 348. Defining the Type and Location of a PPP Inte…

138, Chapter 11: OSPF Configuration Guide 112 SmartSwitch Router User Reference Manual • Type 1 ASE • Type 2 ASE Intra-area paths have destinations within the same area. Inter-area paths have destinations in other OSPF areas. Both types of Autonomous System External (ASE) routes are routes to des…