Cabletron Systems WPIM T1 Operation & User’s Manual

37, Full T1 Configuration Using PPP WPIM-T1/DDS User’s Guide 3-13 7. Use the arrow keys to highlight T1 TX Clock Source. Press the SPACE bar to select Local (no clock source provided by telephone company) or Loop-Timing (clock source provided by telephone company), then press ENTER. 8. Use t…

16, Chapter 1: Overview 1-2 WPIM-T1/DDS User’s Guide 1.1 FIRMWARE REVISION This manual covers Firmware Revision level 02.01.XX. Later revisions may be reflected in an updated manual. Please check carefully to verify the revision level of your device, to ensure that this manual will meet…

19, Cabletron Systems WPIM T1 WPIM-T1/DDS User’s Guide 2-1 CHAPTER 2 SETUP AND INSTALLATION This chapter details set up and installation of the WPIM-T1/DDS into a host platform. 2.1 INSTALLING THE WPIM-T1/DDS For additional support related to the WPIM-T1/DDS, refer to the host platform manual into which th…

45, Frame Relay Configuration WPIM-T1/DDS User’s Guide 3-21 The WAN configuration is complete. Communications between the WPIM-T1/DDS and the service provider’s switch takes approximately one or two minutes to complete. A status of Inactive displays on a DLCI per DLCI basis by def…

40, Chapter 3: Local Management for T1 Service 3-16 WPIM-T1/DDS User’s Guide The following four steps are based on information supplied by the service provider. Consult the service provider for the correct settings. 5. Use the arrow keys to highlight T1 Line Coding. Use the SPACE bar …

57, DDS Service Configuration WPIM-T1/DDS User’s Guide 4-11 2. If Frame Relay was selected, use the arrow keys to highlight FR LMI. Press the SPACE bar to select ANSI_94, NO LMI, T1.617-D, or Q.933-A, then press ENTER. If NO LMI was selected, complete the following: • Use the arrow keys to h…