Comtech EF Data Vipersat SLM-5650A Operation & User’s Manual

75, Chapter 3 - Using the Web Server Interface (WSI) 3-35 Vipersat Configuration Figure 3-42 DPC Configuration (Hub Expansion Demod) Note: The following descriptions will refer to the SLM-5650A as either modula- tor or demodulator for simplicity and understanding. Before enabling DPC,…

146, D-8 Vipersat SLM-5650A User Guide P PLDM Path Loss Data Message – A packet message that is sent by older Vipersat modems (e.g., CDM-570/L) to the VMS every sixty seconds, providing status update and operating parameter information. PSK Phase Shift Keying – A digital modulation scheme …

61, Chapter 3 - Using the Web Server Interface (WSI) 3-21 Vipersat Configuration Power Hunt Power Hunt is a transmission power control feature for the Remote modulator that functions while the Remote is in STDMA mode. This parameter provides compensation for instances when the initial…

56, Vipersat Configuration 3-16 Vipersat SLM-5650A User Guide been assigned slots, the burst map is checked to see if the total cycle length exceeds one second. If not, then all requirements are satisfied and the burst map is complete. However, if the cycle is greater than one second, then…

130, Configuration C-10 Vipersat SLM-5650A User Guide changed from the CLI Calculate Max Power menu (figure C-5). The calculator function is not available from the Parameter Editor because it does not contain the information for the modem BER waterfall curves, which is vital to calculate m…