CDA hn9625 Manual For Installation, Use And Maintenance

23, 23 2.5mm  , HO5RR-F). • This appliance is intended to be connected to the mains supply with a cable of cross section area 2.5mm  . A larger cable will not fit the terminal connections. • The current rating of the fuse or circuit breaker protecting this applian…

7, 7 Using Your Hob Power level Type of cooking 0 Switched o 1/2 For melting (butter/chocolate) or keeping food warm 2/3 Keeping food hot or to heat small quantities of liquid 3/4 Heat larger quantities of liquid (sauces etc.) 4/5 Slow boiling, e.g spaghetti, soups, stews, pota…

8, 8 Using Your Hob To switch the hob on • To switch the power on, touch and hold for approximately two seconds. The hob will beep and all four zone displays will show “0”. Please note: If a power level is not set within twenty seconds, the hob will switch off automatically. To s…

9, 9 Booster • The hob is equipped with a booster function on the front left and front right zones, allowing a higher power level than the maximum for approximately five minutes. To turn on the booster function, touch the zone display for the required zone then touch . “P” will …

5, 5 Important • Do not use the hob if the glass surface is cracked or damaged to prevent the risk of electric shock. Disconnect it from the power supply. • Ensure that the power cable of a connected electrical appliance near the hob is not in contact with the cooking zones. …

6, CDA hn9625 6 Cooking on Induction The principle of induction cooking is based on magnetic eect. When you put your cookware on an induction zone and switch it on, the electronic boards in the hob produce induced currents in the base of the cookware and instantly raise its temperature. This heat is …