Clifford 10.5X Installation Manual

17, © 2005 Directed Electronics, Inc. 17 Light Flash Jumper This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and the unit will output (+)12V on the WHITE wire, H1/11. In the (-) position, the WHITE wire, H1/11, will supply a 10 A (-) …

33, © 2005 Directed Electronics, Inc. 33 NNoottee:: When the shock sensor adjustment mode is exited, the bar indicator will indicate continuously. For example if level 15 was being set (bar 1-7, bar 8 flashing), upon exiting adjustment mode bars 1-8 will indicate continuously. 2. DDeeccrreeaassee S…

25, © 2005 Directed Electronics, Inc. 25 Press button six times 7 light flashes Zone 4 and 7 bypassed Press button seven times 8 light flashes All zones except zone 5 are bypassed NNOOTTEE : Multi-Level Security Arming only applies to a single arming cycle. Once the system is disar…

18, Clifford 10.5X 18 © 2005 Directed Electronics, Inc. System Features Learn Routine The System Features Learn Routine dictates how the unit operates. Due to the number of steps, they have been broken up into three menus. It is possible to access and change any of the feature settings using the Valet/Program button…

35, © 2005 Directed Electronics, Inc. 35 System Status Chirps Table of Zones NNOOTTEE : The Warn Away ® response does not report on the LED. Zone No. Trigger type Input description 1 Instant H1/7 BLUE wire. Connect to optional hood/trunk pins. 2 Multiplexed For the onboard shock se…