Comet Labs RF10 Operation & User’s Manual

13, Comet Labs RF10 User Manual v5.0 13 / 161 1.3.2 Rear Panel      Port Function 1 RESET To reset the device and restore factory default settings, after the device is fully booted, press and hold RESET until the Status LED begins to blink. 3 WAN1 WAN1 10/100M Ethernet port (with …

62, User Manual v5.0 62 / 161 4.2.2 Routing Table The Routing Table displays the current path for transmitted packets. Both static and dynamic routes are displayed. Destination: The IP address of the destination network. Netmask: The destination netmask address. Gateway/Interface: …

96, User Manual v5.0 96 / 161 4.4.5.4 Block WAN Request  Blocking WAN requests is one way to prevent DDOS attacks by preventing ping requests from the Internet. Use this menu to enable or disable function. 4.4.5.5 Intrusion Detection )$�…

72, User Manual v5.0 72 / 161 4.4.1 LAN  There are two items within this section: Ethernet and DHCP Server.    4.4.1.1 Ethernet   IP Address: Enter the internal LAN IP address for the RF10 (192.168.1.254 by default). Subnet Mask: Enter the subnet …

123, User Manual v5.0 123 / 161 5.2 LAN Interface  Refer to this section for issues relating to the RF10’s LAN Interface.  5.2.1 Can’t Access RF10 from the LAN  If there is no response from the RF10 from the LAN: - Check your Ethernet cable types and each connection. -…

45, User Manual v5.0 45 / 161 3.4.4.2 Configuring 1. Select Start > Settings > Control Panel. 2. In the Control Panel, double-click Network and choose the Configuration tab. …