Compatible Systems MicroRouter 900i Installation Manual

31, Chapter 6 - Basic Configuration Guide 25 TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in the IP WAN 0 section. Add static routes and a default router using the edit config IP Static command. Saving a Configuration File to Flash ROM Once a configu…

43, Compatible Systems MicroRouter 900i Appendix E - Terms and Conditions 37 ber of each item being returned; (c) original Compatible Systems Sales Agreement number; and (d) any special instructions. Upon receipt of this information, Compatible Systems will issue an RMA (“Return Material Authorization”) numbe…

16, 10 Chapter 3 - Network Installation For wall mounting, follow the instructions included with the wall-mount bracket kit. Connecting the Router to the Ethernet For thick or thin Ethernet networks, you should have installed your Ethernet cabling before you install the MicroRouter 900…

8, 2 Chapter 1 - Introduction In short, the installation steps are: 1. Install the MicroRouter hardware and connect it to a line commu- nication device (including a modem, 56K CSU/DSU, or ISDN Ter- minal Adapter). 2. Select the management method you wish to use with the router. If you want to u…

37, Appendix C - Light Patterns and Test Switch Settings 31 Appendix C - Light Patterns and Test Switch Settings MicroRouter 900i Light Patterns The MicroRouter 900i uses a number of light patterns on its front LED bar to indicate operating conditions. 2 & 9 on steady: Router is powere…

30, 24 Chapter 6 - Basic Configuration Guide TB: Use configure and set the DLCI keyword in the Frame Relay WAN 0 section. IP Protocol Required for IP There are two ways to set up Frame Relay. One is to set the WAN inter- face as a “numbered interface.” This means that the in…