Comtech EF Data Vipersat CDM-570 Operation & User’s Manual

130, Comtech EF Data Vipersat CDM-570 Firmware Upgrade D-10 Vipersat CDM-570/570L User Guide Figure D-11 Download v1.4.5 and Hard Reset screen When the file transfer is completed, Hard Reset the Modem(s). Upgrade Image 1 on Base Modem to v1.5.1 Get Unit Information to show that v1.4.5 modem code is loaded in Image 1…

73, Chapter 3 - Using the Command Line Interface (CLI) 3-39 Vipersat Configuration Figure 3-51 DPC Configuration screen (STDMA mode) Figure 3-52 DPC Configuration screen (SCPC mode) Note: The following descriptions will refer to the CDM-570/570L as either modulator or demodulator for simplici…

37, Chapter 3 - Using the Command Line Interface (CLI) 3-3 Menu Descriptions Menu Descriptions This section details the CLI command menus and briefly discusses the function of each of the commands available on each menu. Main menu The Main Menu, shown in figure 3-1, allows configurin…

133, Appendix D - Network Migration D-13 Firmware Upgrade the v1.5.3 firmware will lose communications during this time, so a planned maintenance outage is necessary. It is only necessary to download 1 image of the Router to v1.5.3 and reset the Remotes in order for them to rejoin the network…

128, Firmware Upgrade D-8 Vipersat CDM-570/570L User Guide Get Information for Router v1.5.3 Figure D-7 Unit Information screen (Router) The new unit information will show that Image 1 Version=1.5.3 and that the Application Version=1.5.3. The application CurrentBoot should = the image slot lo…

48, Vipersat Configuration 3-14 Vipersat CDM-570/570L User Guide Note: Refer to the Viper Calculator for determining preamble length values to enter at the command prompt. If you not have a copy of the latest Viper Calculator, contact your Comtech Vipersat Networks representative to inquire about a …