Check Point IP690 - Flash Based Sys Installation Manual

22, Check Point IP690 - Flash Based Sys 1 Overview 22 Check Point IP690 Security Platform Installation Guide this document, see the Check Point Support Center at http://support.checkpoint.com/.” on page 2. Note The slot that the PCMCIA card carrier uses also supports other PMC cards approved by Check Point. Power Supplies and Fa…

52, 5 Connecting PMC Network Interface Cards 52 Check Point IP690 Security Platform Installation Guide Caution Cables that connect to the Gigabit Ethernet NIC must be ANSI TIA/EIA-568-A/B compliant (Cat 5 or Cat 5e) to prevent potential data loss. To connect to a 1-Gbps hub, switch, or…

73, Configuring Check Point IPSO with IP690 ADP Interfaces Check Point IP690 Security Platform Installation Guide 73 Note To delete an interface used by VRRP or IP clustering, you must first disable the feature that uses the interface. This is why you deleted the VRRP configuration before you …

36, 3 Performing the Initial Configuration 36 Check Point IP690 Security Platform Installation Guide Performing the Initial Configuration If you do not use DHCP to perform the initial configuration of your Check Point IP690 security platform, you must use a serial console connection (cable inc…

38, 3 Performing the Initial Configuration 38 Check Point IP690 Security Platform Installation Guide Using Check Point Network Voyager Use Check Point Network Voyager to configure and monitor your appliance. To open Check Point Network Voyager 1. Open a Web browser on the host you plan to use to …

2, 2 Check Point IP690 Security Platform Installation Guide © 2003-2009 Check Point Software Technologies Ltd. All rights reserved. This product and related documentation are protected by copyright and distributed under licensing restricting their use, copying, distribution, and decompilation. …