CrimeStopper CS-2000 Installation & Operating Instructions Manual

6, OPERATION REMOTE PANIC PROTECTION To sound the alarm upon command (panic), press and hold the #1 (Large) Button for at least (2) seconds until the siren sounds. Press the same button again to reset panic mode. TRUNK/HATCH POP (REMOTE AUX. OUTPUT 1, OPTIONAL) To pop the trunk (if optional …

1, CS-2000 REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a ™ Remote Alarm System by Crimestopper Security Products Inc. This booklet contains the information necessary for installing, using, and main…

4, WIRING YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both “On” and “Start” positions. BLACK WIRE: SYSTEM CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF…

8, 87A 86 87 30 85 87A 86 30 BATTERY + - IGN EMERGENCY DISARM/ VALET/ PROGRAM SWITCH PIN SWITCH (+)POSITIVE DOOR SW HOOD/TRUNK (-)NEGATIVE RELAY PIN SWITCH OPTIONAL STARTER KILL PIN SWITCH (-)NEGATIVE DOOR LED FUSE BOX + IGNITION "ON & START" START WIRE (-)DOOR TRIGGER YELLOW CUT (-) AUX…

3, CrimeStopper CS-2000 WIRING RED WIRE: +12V POWER INPUT (15 Amp fuse) Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle battery positive terminal. WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (10 Amp Max.) Connect to switched parking light …