Dakota Digital MCL-3212 Update Manual

1, MAN# 650378 MODEL MCL-3212 SPEEDOMETER/TACHOMETER for 2012 – up Dyna and Softail with 4” gauge GAUGE SETUP AND CALIBRATION The setup menus are entered by holding the switch in while turning the key on. The menus are as follows: Menu Description…

2, MAN# 650378 MOUNTING The gauge will mount using the original housing, grommet, and screws. Unbolt the two screws from the back plate at the back of the gauge housing, then unplug the factory gauge, noting the position of the grommets. There is one grommet on the front between the gauge…

3, MAN# 650378 SPEED CALIBRATION The speed calibration is not required unless you have changed out the stock transmission, pulley, or tires. ADJvST ADJvST ADJvST ADJvST Adjust • Press and release the switch until “AdJvSt” is displayed, then press and hold the switch until “ - �…

4, MAN# 650378 Set FC Set FCSet FC Set FC Temperature sender setup The temperature gauge can read the stock head temperature sensor from the ECM. • Press and release the switch until “Set FC” is displayed, then press and hold the switch until “ - ” is displayed. • …

5, MAN# 650378 FUE FUEFUE FUEL LL L Low fuel light and distance to empty setup If the range feature is turned on, the range reading will initially show the word range until a tank of gas has been driven to allow the gauge to complete its setup based on your driving. Begin wit…

6, Dakota Digital MCL-3212 MAN# 650378 Troubleshooting guide Problem Possible cause Solution Gauge will not light up. Red/Orange wire does not have power. Inspect and repair stock harness. Black/Green wire is not getting a good ground. Inspect and repair stock ha…