CrimeStopper CS-2000.III Installation And Operating Instructions Manual

11, CrimeStopper CS-2000.III OPERATING INSTRUCTIONS ACTIVE ARMING To arm the alarm and lock the doors, press the #1 Button (Lock/Unlock Symbol) on the transmitter. You will hear a single siren chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be disabled if these optio…

12, OPERATING INSTRUCTIONS SILENT ARM/DISARM THROUGH REMOTE (BUTTON #2) This system can be armed and disarmed without siren chirps on an “as needed” basis. Press and quickly release Button #2 (TRUNK) to Arm and Disarm system without chirps. NOTE: If Button #2 is pressed too lon…

7, REMOTE TRANSMITTER PROGRAMMING 1. Turn Ignition ON. 2. Press the Program/Override Button 4 times. After a few second delay, the lights should flash 4 times. 3. Press button 1 on the remote control you wish to learn. You should get 2 light flashes indicating the unit is …

14, CARJACK PROTECTION ACTIVE CARJACK This feature provides Active Carjack protection and must be enabled before use through Alarm programming option (14) See page 8. When the Ignition is on (running), press button #2 (Trunk Symbol). Parking lights will flash TWICE to confirm the …

10, OPTION PROGRAMMING 8. SILENT ARMING /DISARMING (CHIRP DEFEAT) With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular Lock/Unlock Button. Flashing parking lights will be the only Arm/Disarm confirmation. 9. PARKING LIGHTS…

9, OPTION PROGRAMMING 1. HORN CHIRPS / PULSES This option controls the system’s Horn-honk output. There are 3 selections: Button 1 (Lock) = Horn Pulse only when alarm is tripped. Button 2 (Unlock) = Horn Chirps for Arm / Disarm and Pulse when tripped. Buttons (1+2) = Horn Chirps f…