Defy Automaid 600 electronic Owner's Manual

8, MAINTENANCE • The Grease filter is located immediately above the perforated plate and is held in place by metal strips. • The Grease filter must be washed every month in a solution of lukewarm water and washing liquid to remove accumulated grease and fats. Allow the filter to dry a…

6, WALL MOUNTING Remove the filters so that the interior of the cooker hood and the keyhole slots are exposed. Hold the cooker hood in position against the wall and with a pencil mark out the location of the keyhole slots on the wall. Using a masonry bit, drill a hole at the top of each…

7, All models can re-circulate air or vent it through an outside wall. Select the venting mode before installing the cooker hood. OPTIONAL REAR OR TOP VENTING INSTALLATION When using the external venting mode, ensure that there is adequate ventilation of the room when the Hood is used…

3, WALL MOUNTING • Remove the aluminium grease filters (perforated plates) from the base of the hood. • The hood must be mounted directly over the cooking area. The minimum distance between the cooking surface and the underside of the hood must be 650 mm. for electric cookers and …

5, CANOPY TYPE CUPBOARD INSTALLATION With this type of installation, (and if the rear vent is not used), the venting hole at the top of the unit must be clear. Remove the perforated plate underneath the unit by loosening the knurled-headed screws on either side. Drill four sui…

4, Defy Automaid 600 electronic ELECTRICAL INSTALLATION Connect the appliance to a 15A 230V 50 Hz earthed wall socket. Switch off the power at the mains in the event of a fault or when cleaning the appliance. CONTROLS These at located at the left front corner under the hood. 32 1 FAN HOB LIGHT OPERATION …